This is what my set up looked like in the end. The resin had lots of bubbles in it which is why it looks white. I removed them by waving a creme Brulee torch ( Another useless item in my kitchen) quickly over the surface and they all disapeared.
Your resin should look like this after the bubbles are removed. I let them sit for 24 Hours and then just turned the moulds inside out to get the out.
The back of mine had some fine rough edges. I used a sanding block with 320grit to remove them, the front came out perfect.
The unicorn spit door knobs did not work as great as I wanted, because I did not mix it in enough with the resin. But was so impressed with the steampunk door knobs, I just need to make a piece of furniture to go with them.Besides being door knobs these can have many uses. They would make great hooks for a coat rack, great for hanging up your necklaces and many more.The possibilities for these door knobs are endless as to what you can add to the resin.
Sources: Hometalk.com & uniquecreationsbyanita.com
TO CONTINUE READING, PLEASE USE NEXT PAGE BUTTON BELOW .. AND DON’T FORGET TO SHARE THIS POST WITH YOUR FRIENDS AND FAMILY ON FACEBOOK.
